Impressum |
Datenschutz |
Shop |
DIY |
TT @ Twitter |
TT-Cabs
Einloggen
Registrieren
Suche
Anzeigen der neuesten Beiträge
Übersicht
Hilfe
Suche
Einloggen
Registrieren
Tube-Town Forum
Technik
Tech-Talk TT-Projekte
YAH100 bias circuit
« vorheriges
nächstes »
Drucken
Seiten: [
1
] |
Nach unten
YAH100 bias circuit
2 Antworten
1721 Aufrufe
0 Mitglieder und 1 Gast betrachten dieses Thema.
kentuckytukker
Full Member
92
YAH100 bias circuit
«
am:
16.11.2020 14:27 »
I have recently completed a DR504 clone with use of the TT chassis as offered for the YAH100 clone. The bias PCB is used to provide individual bias adjustment for each EL34 tube. The DR504 has only 2 of these output tubes. No need for matched pairs of these anymore. I slightly changed the assembly of the bias PCB. The 2 pot.meters are soldered at the reverse side and provided with thumbweels. A small hole is now enough to make the neccessary adjustments. It also prevents to enter to deep into the chassis with the screwdriver. Spare holes for unused tube socket locations have been blinded with filler plates. The blue item on the output socket is a varistor. This(these) is added for additional protection on wiring from both output tubes to the OT primary connections
René
«
Letzte Änderung: 16.11.2020 14:30 von kentuckytukker
»
Gespeichert
the more you drink the WC
carlitz
YaBB God
1.727
never give up
Re: YAH100 bias circuit
«
Antwort #1 am:
16.11.2020 14:41 »
Hi Rene,
how do you connect the varistor?
Pin 3 - Varistor - GND ?
Gespeichert
If you don't know how to fix it, stop breaking it!
kentuckytukker
Full Member
92
Re: YAH100 bias circuit
«
Antwort #2 am:
16.11.2020 15:05 »
Yes, pin 3 to gnd on each tube. I have also added 3 each 300V varistors on the IEC entry socket for additional protection.
mfrgr,
René
Gespeichert
the more you drink the WC
Drucken
Seiten: [
1
] |
Nach oben
« vorheriges
nächstes »