Hi,
hoffentlich gibt es das Buch auch bald über Amazon (Versandkosten)...
Schön klar & deutlich beschrieben, und der Mann hält glücklicherweise auch nichts von Steckverbindungen:
http://valvewizard2.webs.com/Transformers.pdf"Where the mains cable enters the chassis, usually via an IEC inlet, a heavygauge
wire should be
soldered to the mains earth connection
(do not use a push-fit
connector for this),
and the other end is connected to the chassis with a solder tag, as
shown in fig. 1.2. The chassis area should be cleaned with emery paper before hand
to ensure a good electrical connection. The wire should be short and should have the
same colour scheme as the local mains supply. The earth wire is green-and-yellow
striped in Europe"
Und für die "authentischen" Fender- Vintage-Cloner wichtig:
"Where this wire is bolted to chassis is
known as the earth bond, and
it should
be a dedicated screw/bolt, not a screw
which is used to fix some other piece
of hardware which might become loose
over time."
Gruß
Jacob
