Technik > Informativ und Nützlich

assembling and service support

(1/1)

kentuckytukker:
Hello Tube Amp builders,

For my projects I made a service support which will accept several types of chassis. Although I used C-type rails make Unistrut this can be replaced by any type of C- profile as available in the DIY shops. This is just an idea how to make your own assembling/service tool. The photo and constructions drawing may be used as a guideline to construct your own tool. If there are any questions please do not hesitiate to contact me.

Regards, René

kentuckytukker:
This support was designed to accept i.e. the jtm45/px45 style chassis. To use it for i.e. a Hiwatt style chassis it is required to change the dimensions of the 2 side plates to 27x27cm. Also the angle profile should be 27cm long

Navigation

[0] Themen-Index